Speaker
Description
\documentclass[11pt]{article}
\usepackage[margin=1in]{geometry}
\usepackage{amsmath}
\usepackage{graphicx}
\title{Fabrication of Carbon-Backed Thin $^{94,100}$Mo Isotopic Targets}
\author{
\small \textit{Taniya M. Sonowal$^{1}$, K. Kalita$^{1}$, A. Tamang$^{1}$, A. Kumar$^{2}$, S. K. Saini$^{2}$}\
\small \textit{$^{1}$Department of Physics, Gauhati University, Guwahati-781014} \
\small \textit{$^{2}$Inter-University Accelerator Centre, Aruna Asaf Ali Marg, New Delhi-110067, INDIA} \
\small \textit{Email: kkalita@gauhati.ac.in, taniyasonowal024@gmail.com}
}
\date{} % Empty date to remove the date from the title page
\begin{document}
\maketitle
\thispagestyle{empty}
\begin{abstract}
Isotopically enriched $^{94}$Mo and $^{100}$Mo targets of thickness $\sim$162 and $\sim$154~$\mu$g/cm$^2$, respectively, have been fabricated on natural-carbon ($^{nat}$C) backing ($\sim$40~$\mu$g/cm$^2$) by electron-gun evaporation for heavy-ion-induced nuclear reaction studies. Owing to its high melting point (2623~$^{\circ}$C), direct evaporation by resistive heating is difficult. Hence, an electron-gun evaporation system was employed for the deposition of Mo. These targets are fabricated for use in quasi-elastic scattering and transfer reaction measurements with heavy-ion reactions.
Carbon backing foils were prepared by first depositing BaCl$_2$ as a parting agent on glass slides by resistive heating $\sim$0.736~k\AA\ on an INFICON SQM-160 monitor), followed by e-gun evaporation of natural carbon to a thickness of $\sim$40~$\mu$g/cm$^2$, without breaking vacuum. The carbon-coated slides were annealed at $\sim$300~$^{\circ}$C for 30~min in argon to relieve stress and mounted on target frames. Trial depositions with natural Mo, carried out at $\sim$$10^{-6}$~Torr, were used to optimize e-gun current and source-to-substrate distance before evaporating the enriched $^{94}$Mo and $^{100}$Mo material. The glass slides were floated using a warm-water before mounting on stainless-steel target frames.
Target thickness was confirmed by stylus profilometry, and elemental composition was checked by SEM-EDS, which showed only Mo with no high-Z contamination.
\end{abstract}
\end{document}