Speaker
Description
Blazars can change greatly in brightness over time, and this variability is often linked to disturbances moving through their relativistic jets. If opacity is the main cause of the observed delays, a flare should first appear at higher frequencies and then later at lower frequencies as the emitting region expands and becomes optically thin. In this study, we investigate how well this expected pattern holds across six bright blazars. We use long-term observations from Metsähovi at 37 GHz together with ALMA calibrator light curves at 90, 230, and 345 GHz.
We measured the delays between the different frequency bands using four methods: ICCF, ZDCF, JAVELIN, and PyROA. This allowed us to compare results from both correlation-based and model-based approaches. Three sources, 3C 273, 3C 279, and 3C 454.3, show clear frequency-ordered lag patterns. In these sources, the largest delays are found between 345 and 37 GHz, which broadly agrees with the expected movement of a disturbance through different regions of a stratified synchrotron-emitting jet.
The other three sources show less regular behaviour. PKS 1749+096 mainly follows the expected trend when comparing the most widely separated frequencies, while OJ 287 shows a partly distorted lag sequence. NRAO 530 is the clearest exception, as the results suggest that the lower-frequency emission may lead the higher-frequency emission, rather than appear later as expected if opacity were the only important effect.
These differences may be caused by jet bending, changes in Doppler boosting, standing features in the jet, overlapping flares, or emission regions that are located close together at millimetre wavelengths. Overall, the results show that inter-band time lags can provide information not only about how disturbances move through a jet, but also about the individual structure and behaviour of the emitting regions in each source.
| Scientific session | Blazar emission zones: Multi-band variability and polarisation signatures |
|---|